Roger G.
Works pretty well on my CR-20 Pro
Jim T.
It was a way lighter grey than I was expecting. Basically an off-white
Chris R.
My go to filament and works well with any of my printers.
Robert A.
Great value and seems consistent from roll to roll. The winding is a little unsettling to look at compared to higher end brands but it's just appearances. I've gone through about 15 rolls of the value PLA and only one had actual issues with the winding where it was tangled in three different places on the spool. I go through a lot of PLA so saving a few dollars on each roll adds up.
Liza O.
Getting great print form this filament.
duc n.
The best PLA filaments. Excellent for 3d print rc plane. Thank you.
duc n.
Excellent filament for rc plane. Will buy again.
Dalibor B.
One of the first prints on my new 3D printer and the result was amazing. Feeling very confident to work with the filament.
Scott L.
Heads up Nothing but jams and clogs, I've tried 4 different rolls that I got from a 5 roll order if you run in to this don't start fixing 3 printers :D
Tried in Ender 3 with DD, requires me to print at 245c to avoid clicks
Tried on a Tronxy X5SA with Hemera Direct Drive, ends up not extruding a couple layers in (Tried 200c to 240c) and it's 0.5mm retraction
Tried on a Ender 5 Plus with full Micro Swiss direct drive, exact same issue as the Hemera
Michel G.
Let’s face it! I am poor, well not really, but I am a little cheap. So this is my go-to filament for everyday prints.
I have bought about 10 spools of value PLA and it does the job. No surprises. The white and the grey are quite similar but that is ok. The colours are nice and give good results. I print mainly RPG terrain and board game box inserts. No hesitation in recommending this line of product.
Henri C.
Good quality filament.
Ron B.
Have been using the standard PLA in many different colours and it works great in my CR20
John -.
Very happy with service and product!
David B.
Extremely good filament. Price is right and gives high quality results. Have already gone through the spool and am buying more. Just wish there we more variety in available colours for the same price but either way great filament!
Larry D.
I really like It was one of the best PLA I have used
duc n.
Keep the same great quality. I will keep buying from the same brand.
Thomas B.
Nice PLA for quick prototyping. Took a little while to get it dialed in properly with a 0.3mm nozzle, but overall, it's a great product for its price point.
Eric I.
Very good PLA for the price. Would recommend.
Our Address
