White - 3D Resin Solutions HARD Rapid ABS - 1 kg In stock

Wrote my initial review on the gray resin of this type but just as a continuation to my experience of this resin (I've bought both colors)... it's been a pain to use. Not because it prints badly, I think it does a good job at printing and keeping details (then again this is the case with most resin printers).. but with it's mechanical properties. As stated in my previous review, at normal curing times, it reaches ~79D hardness (slightly harder than standard resins which usually sit at 77D), with over-curing being capable of reaching ~82D. However, when curing the piece 10 minutes or more (which was required to reach the higher hardness levels) it becomes extremely brittle to the point that it is just all around useless for mechanical parts. My use is a plastic threaded part that is held on by a screw on one side and the other (threaded) side holds on to something, replacing an old plastic one that broke... and it just does not have the properties to do this. At low curing times, it is too soft and deforms after just a day of holding the part. At high curing times, it cracks when screwing the piece in. I've tried many resins and though many didn't pass my requirements, their spec sheets are telling of why they failed. This however was looking like a siraya tech blu competitor in terms of hardness and tensile strength (from the spec sheet), but in reality it fell short in every category. Im still on a quest for a resin that can match the specs of a blu/scuplt ultra mix but being easier to clean and seems that it just is not going to be possible without spending 200+/liter.

Nice surface texture for dental models.

Optimized for fast printing. More like no setting available for standard printers without a monochrome screen. Another useless poorly described product.