Kora 3D Formula 3D 100ml Out of stock

SPECIALIST 3D MODEL TO 3D PRINTER BUILD PLATE ADHESIVE

Directions for use:

UNSCREW TO REFILL - PULL TO OPEN

Unscrew foam top and pierce the silver foil bottle seal, replace top firmly. PULL off the bottle cap, (PULL do not unscrew).

Gently shake the bottle then press the foam top against the build plate 2 or 3 times. Use the foam top to evenly spread Formula-3D across the intended print area. Allow to dry to ensure your print sticks firmly to your build plate surface. (To speed up the drying process turn on the build plate heaters after application - do not apply to a hot build plate - if hot, allow to cool before application). That's all you have to do!

For consistent results, re-apply frequently, especially where previous prints have been removed from the build plate.

Occasionally use a damp sponge, scouring pad or cloth to evenly redistribute or remove any Formula 3D adhesive build-up.

Specially formulated for use with FFF/FDM 3D Printers

Formula-3D is a specialist adhesive that allows you to coat your 3D Printer build plate and MAKE your 3D model prints stick fast! Suitable for most filaments. Suitable for most build plates.

Environmentally friendly. Safe, Odour Free Formula. Suitable for heated (Max. 100’C) and non heated build plates.

IT JUST STICKS!

Not considered harmful in normal use following guidelines below:

Avoid eye contact – if this occurs wash with clean water & remove contact lenses if worn and safe to do so. Do not swallow - if this occurs drink plenty of clean water. Skin contact should be kept to a minimum wash skin after any contact with soap and water. If any symptoms persist, seek medical advice.

Product contains: Aqua (water), Denatured Alcohol, Other Ingredients. Use only as directed. Protect from direct sunlight. Keep out of reach of children. Alcohol content <24%

Safety Data Sheet