Official Creality CR-10 V2 V3 v2.5.2 Control Board In stock
Creality Board v2.5.2
- CR-10S V2 6001020016
- CR-10S V3 2101020030 and 2002040060
- CP-01 3 in 1 4002020028
Upgraded Silent Board with TMC2208 Driver For Creality CR-10S V2 3D Printer
-Super Quiet and Noise Reduction. Use TMC2208 Stepper Motor Drivers, which the key component to eliminate the printer's motor when printing.
-Bootloader pre-installed. The firmware can be modified by ARDUINO or Cura with the USB cable.
-Concern for safety. Thermal runaway protection is enabled, if the temperature rises out of control, the printer will stop heating and halt automatically.
- Stepper Motor Driver based on TMC2208
- Voltage: Works on 12V and 24V
- Can Work For other Creality printers with full size SD card reader.<You need to flash the firmware then you could use it> Firmware Download
Creality V2.5.2 PCB:
Different from Regular V2.2.0, Board, in the position of stepper motor driver chip, the resistance value is different (can be directly observed on the motherboard).
Conventional: R100 Resistors
Silent/mute: R150 Resistors