Official Creality BLTouch Auto-Bed Leveling Sensor Kit - 8bit In stock
Probe is V3.1
BLTouch is a type of semiconductor hall sensor and is an electronic component for 3D printers.
IMPORTANT: This kit is not intended for the CR-10S Pro or Ender 3 Series with V4.2.2, V4.2.7! (Further details below.)
BLTouch is an auto levelling sensor for 3D Printers that can precisely measure the tilt of the Bed surface. It could work with any kinds of bed materials, such as glasses, woods, metals, and so on.
The main functions and controls of BLTouch are the same as the usual auto bed levelling sensor, which consists of RC servo and microswitch. Thus, BLTouch can be applied on almost every board.
BLTouch is fulfilled with simple structure and high precision by using progressively designed solenoid and hall sensor. It aims for user convenience and enjoyable printing by adding many smart functions, such as self-test, alarm, alarm release & Touch Switch mode, Blue LED for servo signal indicating and Z-probe(Zmin) Testing.
Self-test: The push pin operates two times in a test when the power is on.
Alarm: The LED light blinks if a problem was found on a self-test or during operation
Wiring defect indicator: Blue and Red LED for indicating wiring defects.
Please note this comes with a 1.5-meter extension cable suitable for the Ender 3, Ender 5, CR-10 and CR-10S.
Note for CR-10S Pro users: Please purchase the ANTCLABS SM-XD-2000 cable and Genuine ANTCLABS BL Touch for your machine. (You need the jumper included in the Genuine BL Touch package. You do not require the USB ISP included in this kit. The included metal mount bracket in this kit is not for the CR-10S-Pro which has a different shroud and carriage plate.)
Note for Ender 3 Pro V2 users: You will need to use the Pin27 header Adaptor and "With Adaptor " Firmware .
CR-10 V2, V3: https://www.thingiverse.com/thing:3940873
CR-10S Pro V1: https://www.thingiverse.com/thing:3338711
Ender 3 V2: https://www.thingiverse.com/thing:4462870